Archives

Cross fittings are often used in industrial processes, particularly in complex piping systems where multiple branch connections are needed.

A cross fitting is used to create a branch in a pipeline with four openings at right angles to each other, allowing for the flow in multiple directions.

Concentric reducers have a common centerline for both ends, while eccentric reducers have one end off-center, often used to maintain a level flow or drainage.

Reducers are used to connect pipes of different sizes or diameters, allowing for a smooth transition in the flow of fluids.

Yes, there are equal tees, where all three openings are of the same size, and reducing tees, where one of the branches is smaller than the other two.

A buttweld tee is used to create a branch in a pipeline, allowing the fluid to flow in three different directions.

In some cases, you can request custom bend radii to meet specific project requirements, but standard sizes are readily available.

The choice depends on the space available and the desired flow characteristics. A 1D elbow is more compact, while a 3D elbow provides smoother flow.

These terms refer to the radius of curvature of the elbow. For example, a 1D elbow has a radius equal to the nominal pipe diameter, while a 5D elbow has a radius five times the nominal pipe diameter.

Yes, you can find 180-degree elbows in various materials, allowing you to choose the one suitable for your specific application.